Eclair Cameras: A-minima loads

[Steven Gladstone <veenotph@earthlink.net>]

EclairACL@topica.com wrote:


> If you are familiar with loading a core load then you will have no 
> problems with the Aminima loads.  They are nothing more than core loads 
> with removeable daylight flanges.  


Remember to remove the flanges as has been mentioned. The A-Minima load 
is designed for a camera that has a small rubber wheel that slightly 
spreads the Plastic Flanges where the film goes past. Theis is because 
the Flanges are actually designed to seal against the film on a full 200 
foot load, for additional light protection. Failure to spread the 
flanges as the film enters can cause noise, and damage to the edge of 
your film.

--
Steven Gladstone
Cinematographer - Gladstone Films
Cinematography Mailing List - East Coast List Administrator
Better off Broadcast (B.O.B.)
New York, U.S.A.

==^================================================================
This email was sent to: elroro@propagandaindustries.org

EASY UNSUBSCRIBE click here: http://topica.com/u/?a84xYK.bdbHPA.ZWxyb3Jv
Or send an email to: EclairACL-unsubscribe@topica.com

TOPICA - Start your own email discussion group. FREE!
http://www.topica.com/partner/tag02/create/index2.html
==^================================================================