[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Eclair Cameras: ACL serial numbers. 1, 1.5, 2?
Thank you for the insite on the light leak on the 200ft. mags. I don't have
a 200 footer. Does this happen with th 400 ft. mags??
----- Original Message -----
From: "august loessberg" <firstname.lastname@example.org>
Sent: Friday, June 13, 2003 8:46 AM
Subject: RE: Eclair Cameras: ACL serial numbers. 1, 1.5, 2?
From: august loessberg [mailto:email@example.com]
Sent: Friday, June 13, 2003 8:33 AM
Subject: To all users. Re light leaks in 200 magazines.
Most users may have noticed this problem with 200 mags already. But
every 200 mag I have ever seen has a serious light leak. It is caused by
the shrinkage of the sound dampening material used inside the doors on
sides. Remember that any 200 mag is already 25-30 years old and the high
density rubber foam insulation shrinks with age.
If you own a 200 mag use should cover the opening inside the door, just
under the locking latch with a piece of black camera tape.
When the camera is still and on set, light filters through this opening
fogs 2-3 frames of film next to the opening. It shows up in post as flair
that occurs approximately 29-35 frames from the start frame of each shot.
So common is this problem that I immediately correct this problem on every
magazine I service.
Help STOP SPAM with the new MSN 8 and get 2 months FREE*
This email was sent to: firstname.lastname@example.org
EASY UNSUBSCRIBE click here: http://topica.com/u/?a84xYK.bdbHPA.ZWxyb3Jv
Or send an email to: EclairACLemail@example.com
TOPICA - Start your own email discussion group. FREE!