[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Magazine Question.



I'm not an expert on this, but if the belt is moving then I'd guess one of two problems:

1) Take-up spindle assembly has a problem (you might try swapping the spindle assembly from the 200' mag into the 400' mag as a test; if the 400' mag then works, you've at least isolated the trouble)

2) Motor doesn't have enough torque for the 400' mag. Put a 100' dummy load into the 400 foot mag and see if pulling on less film allows the mag to take up. If a 100' load works ok, then it may very well be that the motor can't handle 400 feet.

Good luck. Mark.

==^================================================================
EASY UNSUBSCRIBE click here: http://topica.com/u/?a84xYK.a9svPI
Or send an email To: EclairACL-unsubscribe@topica.com
This email was sent to: elroro@propagandaindustries.org

T O P I C A -- Register now to manage your mail!
http://www.topica.com/partner/tag02/register
==^================================================================